Does anyone have exact measurements for the placement of the powerfeed tube?
First three are easy, they could be measured off any PF.
PF Tube ID:
PF Tube OD:
PF Tube Length:
But what about the following?
PF Tube Center to Body Tube Center:
PF Length from center of opening required for parabolic plug:
With those measurements and a CAD file that I already have, I would like to try and fabricate a custom classic mainbody. I'd rather not do this by trial and error as the cutting work is going to be expensive.
Additionally, does anyone know of a clamping feed neck that could be installed on a centerfeed?
First three are easy, they could be measured off any PF.
PF Tube ID:
PF Tube OD:
PF Tube Length:
But what about the following?
PF Tube Center to Body Tube Center:
PF Length from center of opening required for parabolic plug:
With those measurements and a CAD file that I already have, I would like to try and fabricate a custom classic mainbody. I'd rather not do this by trial and error as the cutting work is going to be expensive.
Additionally, does anyone know of a clamping feed neck that could be installed on a centerfeed?