Trigger stops for intelliframe

[blamtro]

I have an intelliframe with double trigger and want to add trigger stops to it. Who can help me with that. From what I have seen, people dont just use ordinary set screws?

Mike

[ultralight]

no, they use ultra super duper special tiny set screws.

sorry, yes they use regular set screws. just take your trigger with you to the hardware store and choose some appropriately sized set screws, and it doesn't hurt to pick up a specific allen wrench either.

after that it's just drilling and tapping. and of course, the mowing.

good luck.

[blamtro]

what keeps the set screws from tearing up the soft aluminum trigger frame?

[Skoad]

nothing, just will make a little mark in your frame behind the trigger. No big deal really.

[Big'n slo]

Pick up a couple Nylon tipped set screws if your worried about marring.

http://www.mcmaster.com/

Pg 2915

[Yogster]

Lets see some pics of it finished.I was actually gonna temp to do it.Just wasn't sure where to place the set screw for best performance.

Yogster

[luke]

You can see where to put your screws here>>

http://www.lukescustoms.com/page0015.htm

Use 6-32 x 3/16" screws.

[ultralight]

luke, none of your pics are working. i'm getting the red x'es of frustration.

[luke]

It seems like a few people are having trouble at my site.

http://www.lukescustoms.com/page0015.htm

Try again, I did some work to it today.

Here's a picture of a two stop trigger.

[ultralight]

thanks. it's running really sweet with them. especially thanks to your sear mod.

[luke]

Yea, stops are a must with the sear mod, lots of slop left over.

[Scott Hudnall]

here an old thread regarding this.

trigger stop thread