New idea for lightening a PNEUMAG trigger pull

[imaginer123]

Notice that I used the top hole in the MSV-1 when mounting it to the frame. This positions the nail at a certain location on the trigger. This location is a little too low because the trigger pull is a little heavier.

that is a quote out of phisphens talking about how his valve actuator is way to low as seen in this pic

http://img372.imageshack.us/img372/2829/pnuemag2029bu8hf.jpg

but as you see in that pic also is that there is no way to move up the MSV-1 due to the MPA-3 being in the way

so i have an idea that may make acuator point alot higher on the trigger

1. switch the hoses on the MSV-1 (so like on phisphens gun it would actually shoot on release not pull)
2. then you customize a little lever that when the trigger hits the top part the bottom kicks out activating the 2 MSV-1

the only problem would be is that the MSV-1 needs to be somehow spring returned




ANY OTHER IDEAS???

[ZapTheMad]

make the lever a backwards "L" shape and point the switch upward.

I dont think the switch works with the hoses reversed. The outlet port is exhausted to atmosphere when the switch is closed.

[imaginer123]

make the lever a backwards "L" shape and point the switch upward.

I dont think the switch works with the hoses reversed. The outlet port is exhausted to atmosphere when the switch is closed.

or i can make it 2 levers so the 2 will cancel the reverse action and make it like a regualr pull