Phantom Feed Tube Measurements?

[camilion705]

Would anyone mind measuring the length in inches of their 10/15rd feed tubes that screw into the feed port of their phantoms? (Including end cap) I also need to know the diameter of the tube. Any help is greatly appreciated. I am working on a SC feed system for my sniper and would like to use phantom feed components if at all possible.

EDIT: I also need the inner diameter of the end cap. (the side that slides onto the feed tube.) Thanks!

(Picture from WWA.)

[wanna-b-ballin']

yeah, i'll measure all the aspects of my 15 rounder. can't do it now though, i'm supposed to be taking a final.
after school i'll do it.

[wanna-b-ballin']

with end cap its 8 and 3/8 inches long.
without the endcap its 7 and 5/8 inches long.
ID is 744 thousandths or 3/4 of an inch
OD is 875 thousandths or 7/8 of an inch
ID of endcap(where tube goes in) is 875 thousandths or 7/8 of an inch.

the threads on the tube taper. skinny end is 808 thousandths.
fat end is 848 thousandths.

i dont feel like doing any conversions right now(had a math final), so i'll leave that to you.

[camilion705]

Thanks a bunch. Now I can make a proper SC Feed System for my Sniper II...