Pump Conversion Question

[jhardy66]

Alright, I have asked this question on numerous forums and so far, no luck...so thought I would try here too!

I have an original PMI Piranha marker (one of the first 300 to roll off the assembly line) that I would like to convert into a pump gun. Is this possible with a CCM Pump Kit? If so, how hard/expensive would it be? I know that it is probably easier to just buy a pump, but this gun has served me well for several years now and deserves to have it's life extended. And the only way I am going to use it instead of my 05 Sonic Cyborg or 2 AGD RT Pros is if it is a pump. Can anybody give me any advice or direction, etc?

Thanks guys...I know that this is not an AGD Marker question, but figured there has to be somebody here that can help.


Thanks!

[jhardy66]

Anybody?

[jhardy66]

Somebody has to know! Anybody?!?! I'm lost and have no clue about it.

[chewy]

I was planning on doing the same thing to my viewloader triad (spyder clone). First, you have to make it no longer blowback. Someone told me that a valve from a Sheridan PGP (I think) would go in there. Then, you must rig up a pump handle and linking arms back to your cocking knob, and voila, you now have a pump.

[jhardy66]

Thanks. That gives me an idea of what I need to do to it. Now I can start plotting how much and a time frame. Any more advice or help is welcomed as well.

Thanks again.