Pnuemag Problems

[WakeJake05]

OK i have my pnuemag basically finished, only problem is that when i have the pressure low enough to walk it, it keeps a constant leak. i did the same design as project red-eye except used a fabco instead of clippard,

[BigEvil]

OK i have my pnuemag basically finished, only problem is that when i have the pressure low enough to walk it, it keeps a constant leak. i did the same design as project red-eye except used a fabco instead of clippard,

Where is it leaking from? Also, what gun do you have it on? RT, Classic, ULT/RT on/off ect.

[WakeJake05]

it is on my x-valved gun with chimera, it leaks down the barrel at times, it didnt do this until i did the mod, and also leaks in the 3way. if i turn up the pressure more it stops, but then the trigger pull is very heavy, anyway to fix this?

[BigEvil]

Look and see if your ram is pressing against the sear.Most people say there should be a little space between your ram piston and the sear (Pretravel)

Also, if you milled or grinded meat out of the frame, it might be flexing when you screw the body together. Check the fromt frame and field strip screw. A gun leaked down the barrel on me once, and when I loosened the front screw a little it would stop. When it leaks down the barrel, does it stop when you put inward pressure on the bolt?

[WakeJake05]

yeah if i push the bolt in, it will stop