Too advanced for full auto?

[e-qwiped]

I read the thread written from jtcass about full auto mag? and took the advice about removing one of the on/off valve pin o-rings but havent tried it yet cause im skeptical. i have an X-valve and ult and i only saw one o-ring i could remove neway (top of valve) can this work?

[GoblinGreen]

I would have to say No. Not in the sense that it wont work more in the sense that its pointless. If you are running a X-valve rather increase your input pressure and go for an easier reactive trigger(bounce).

[Recon by Fire]

No O-ring = runaway?

[RedEyes]

I think you use stock on/off and increase it to over 900psi(the higher the better). check out Z-Man has videos and how to's.

[geekwarrior]

i think you need the stock on/off. I'm not sure if its the top orings, or the one inside the on/off.