I have a question. I dont know if it is offered by anyone, but is there a way to put an aftermarket clamping feed neck on a vertical Xmag breech? I have had an Xmag before, but was made an offer that I couldnt refuse. So, I sold it, only had it for about a week. While I had it, I did take it completely apart, just to see how it was put together. Knowing how its put together helps to troubleshoot probs. ANYWAY, while I had it apart, I noticed that the feedneck seems to be either braized or a damn tight fit. I also noticed that there was a set screw that seemed to be holding it in place. What I have in mind is this: Can a clamping feedneck, such as the type an EGO or Etek has be fitted onto the Xmag? I think that this type would be the easiest to fit, but I dont know for sure. Any thoughts?
- AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026. Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Comment