my pneumag - vid and pics

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • CaliMagFan

    #1

    my pneumag - vid and pics

    hey guys.. just spent the better part of the last week finishing this one up... I guess its not 100% cause i have to locktite everything, but it shoots and it shoots fast... so yay...

    there are like 2 barrel breaks in the vid... something weird with my barrel, they seem to break in the last 2 inches, might be the balls, i dont know.

    youtube vid- http://www.youtube.com/watch?v=y_1LNDh2PHE

    some pics-



  • geekwarrior
    MIA
    • Oct 2005
    • 2581

    #2
    not bad, looks pretty clean.




    and why does everyone who makes a vid run out of air or paint?

    Comment

    • captian pinky
      Bearded Works

      • Oct 2004
      • 2755

      #3
      beacause their so much fun to shoot wouldn't u run out unless u owned a paint store and had a compressor i think so

      Comment

      • geekwarrior
        MIA
        • Oct 2005
        • 2581

        #4
        Originally posted by captian pinky
        beacause their so much fun to shoot wouldn't u run out unless u owned a paint store and had a compressor i think so

        i'm just saying, for the vid, maybe have a full tank

        Comment

        • benzy2
          Registered User
          • Jul 2002
          • 546

          #5
          What did you use as the piston for the mpa3?
          Why doesnt anything work for me.

          Comment

          • CaliMagFan

            #6
            i started out with a piece of aluminum that is just like the one that attaches the qev to the barb in the picture in my first post... I just drilled through the piece with a 5/32 bit and then tapped it for 10-32... then i had to use a dremel and a bench grinder to make it a nice cylinder... kinda tedious, but not the end of the world... the only other part that i used that doesnt come with the mpa3 is the 1/2 inch or so long 10-32 screw that is used to adjust the "rest" length of the mpa3 piston.

            oh yeah.. if you need one the those parts for the mpa3 i can make you one.. free, just have to send me a self adressed stamped envelope... pm me if needed.

            -kr

            Comment

            • benzy2
              Registered User
              • Jul 2002
              • 546

              #7
              Originally posted by CaliMagFan
              i started out with a piece of aluminum that is just like the one that attaches the qev to the barb in the picture in my first post... I just drilled through the piece with a 5/32 bit and then tapped it for 10-32... then i had to use a dremel and a bench grinder to make it a nice cylinder... kinda tedious, but not the end of the world... the only other part that i used that doesnt come with the mpa3 is the 1/2 inch or so long 10-32 screw that is used to adjust the "rest" length of the mpa3 piston.

              oh yeah.. if you need one the those parts for the mpa3 i can make you one.. free, just have to send me a self adressed stamped envelope... pm me if needed.

              -kr
              Im going to harbor freights tomorrow to see if they ahve rivnuts in stock. If not Ill give you a pm. I never thought about putting the part on the dremel and then running it on the grinder.
              Why doesnt anything work for me.

              Comment

              Working...