Ugh. Yet more problems. I have been having a bad time lately with my markers. First my viking goes down mysteriously and now my matrix is on the fritz.
It is a Gen E matrix
Problems : I've been told by the PBN guys that I need to adjust/reset my regs...Ofcourse no one manages to tell me how to do this, they simply refer to the "sticky"...Which is probably the least amount of information one can give.
With that being said :
I turn my matrix on. My CP reg is set to 0 psi. My PBC LPR is turned all the way in.
1 -Nothing.
2 -As the pressure increse the bolt slowly creeps forward.
3 -If I turn off the air supply, push the bolt back into it's rear position and then start the air again it will either make a small pop and then fire (without me pulling the trigger) or the bolt will slam forward and fire as well as vent air.
Regardless of what I set my lpr to the marker will flat out refuse to fire when I activate the trigger and the bolt will simply slam forward. Setting my input pressure will cause the bolt to fly forward.
With all that being said, I am quickly losing patience in this. Everything is lubed, all O rings are in fine condition and the battery is fine. I'd really prefer to fix it myself rather than send it away but it's very frustrating, so any help anyone can give would be greatly appreciated
It is a Gen E matrix
Problems : I've been told by the PBN guys that I need to adjust/reset my regs...Ofcourse no one manages to tell me how to do this, they simply refer to the "sticky"...Which is probably the least amount of information one can give.
With that being said :
I turn my matrix on. My CP reg is set to 0 psi. My PBC LPR is turned all the way in.
1 -Nothing.
2 -As the pressure increse the bolt slowly creeps forward.
3 -If I turn off the air supply, push the bolt back into it's rear position and then start the air again it will either make a small pop and then fire (without me pulling the trigger) or the bolt will slam forward and fire as well as vent air.
Regardless of what I set my lpr to the marker will flat out refuse to fire when I activate the trigger and the bolt will simply slam forward. Setting my input pressure will cause the bolt to fly forward.
With all that being said, I am quickly losing patience in this. Everything is lubed, all O rings are in fine condition and the battery is fine. I'd really prefer to fix it myself rather than send it away but it's very frustrating, so any help anyone can give would be greatly appreciated
Comment