X-Valve- Emag Valve - Rt Valve

[Wolfboyz]

What are the differences between these 3
i know i could put the x valve to replace my classic
but could i swap the classic for a rt or emag valve?

[going_home]

What are the differences between these 3
i know i could put the x valve to replace my classic
but could i swap the classic for a rt or emag valve?

The classic RT valve has a banjo bolt, not just a thumb screw, and cannot be swapped
for any other valve.

Xvalve = The best. light, made from aluminum. will take a ULT trigger kit.
Emag valve. Same as the Xvalve EXCEPT its made from stainless steel.will take a ULT .
RT Pro valve. Same as Emag but it WONT take a ULT .

Those are the top three valves in the AGD lineup.

[p8ntbal4me]

The classic RT valve has a banjo bolt, not just a thumb screw, and cannot be swapped
for any other valve.

Xvalve = The best. light, made from aluminum. will take a ULT trigger kit.
Emag valve. Same as the Xvalve EXCEPT its made from stainless steel.will take a ULT .
RT Pro valve. Same as Emag but it WONT take a ULT .

Those are the top three valves in the AGD lineup.

I have 2 emag valves that will not take ULTs. They were valves set to be sent to PTP for a micro emag setup. My brother has a valve on his micro emag (different lable on the side) and it will not take the ULT. I had mine tapped out for the ULT for 15 bucks per valve.

Just an FYI.

[txaggie08]

the retro's and some of the emag valves had to be machined to tak a ult.

[MANN]

the retro's and some of the emag valves had to be machined to tak a ult.

agreed

[Wolfboyz]

so i could swap my classic valve for an emag valve put a ult and make a pneumag kit and it could be fast?

[MANN]

If your emag valve was milled out for a ult. Not all of them are. I have one of each.

[Wolfboyz]

can i get the one with the ult of u?

but that swap would work?

[txaggie08]

Yes it would. im shure somoene like RR, luke, tuna etc. could mill a valve if ti didnt have it...