Forseeable problems

[Toll]

I figured I may as well ask now, rather than have a headache later

I finally got the pnuemag guts to fit inside of the shocker frame with only a wee bit of filing/etc The problem is that the valve screw hole is about 1/16th of an inch off of where it would be normally. The valve still fits on, how ever it is farther back than it would normally be and it is rather noticeable. Would this cause an issue with the pin/seer?


Just curious.

[longi]

which valve are you using?

[Toll]

Emag valve

It looks like the seer still triggers the pin but I wont know for sure until I can get the guts assembled.

[longi]

Ahh i see, ok, if you get movement from the valve when fires then you may get wear, however, there's only one way to find out! I'd probably be inclined to try it to see what happens. I think you'll get some wear somewhere though.