RT on off on a Micromag and a trigger question

[James Blond]

I was wondering if I could put a RT on/off on my micromag in order to reduce the trigger pull. I don't know for sure, because I can't remember if the micromag valve is actually smaller than a regular classic valve or not. If someone could enlighten me that would be awesome.


Second question, Does anyone make replacement trigger for 2x finger benchmark frames that make the trigger pull shorter and help reduce the shortstroking problem of the benchy?
If so how much do they go for and who sells them?

Thanks

EDIT: If this should have been in the tech forum I apoligise. Could a mod please move it if this is the case.

[Automagrt666]

The Micromag valve (not the RT Micromag valve) is 100% identical to the 68 classic valve to my knowledge, the only difference being the laser engraving. And from what I understand you can put an RT on/off assembly into the valve to reduce the weight of the trigger pull (by about 1/2 I think). I don't know any kind of trigger that would reduce short stroking that isn't electronic/pneumatic since short stroking is done by not completing a full trigger pull. Hope this helps.

Nick