Question about board

[wjr]

I just got an ICD board in the mail to use in a electro pneu project at some point. I thought that it was going to be super small, like the chaos board is. But it's not. I can't see a way how I'd be ablt to fit it in an intelliframe.

Pic:



I noticed though that there are only... er... what's the word? Little electric things (?) on one side of the board. It looks like there's lots of empty space where nothing's going on.

So, could I cut the excess breadboard (at least I'm pretty sure that's what it's called...) off and still have it work? I'd be doing this to make it smaller of course.

[Pneumagger]

looks like it might be a multilayer board. Also, there seem to be two sort of commections (or grounds on the far end. I would guess choping the board might break it.

However, if you know the board isn't suitable - there's no harm in trying, eh?

[wjr]

I tried it last night as a matter of fact. It works perfectly, and now it's about a third of the size.