my Pneumag attempt

[PBChappy]

well I started work on my pneumag today and i having a little bit of a problem on mounting my msv-2 to the frame here are some pics.

here is the frame after i removed some metal for the msv-2


and here is the msv-2 siting in the frame


so you can see the holes dont line up with the inteli frame holes. so any help on mounting this would be great

[captian pinky]

i say make ur own holes

[reckid1986]

yup drill your own holes get some 6-32 half inch screws and tap the holes and bolt it down. thats what i do.

[PBChappy]

ok got the mvs-2 in now i have a 4-40 tap but what drill bit do i use for that

[longi]

You can use any drill bit so long as it's smaller than the tap.

[y0da900]

ok got the mvs-2 in now i have a 4-40 tap but what drill bit do i use for that

3/32 or a #43

[Spider-TW]

I wouldn't go more than a step smaller (#44) if you can help it. #4 taps are fragile and the closer you can get to the thread size the easier it will be. The #43 is the designated size (0.089 inches) for a 4-40 if you have it.

[PBChappy]

woot progress!!! msv-2 mounted, trigger rod done, and piston built and in place.




just have to run hoses and setup the lpr then wait till the local pro shop opens so i can get some hpa

[PBChappy]

well hoses run and tickler setup


but i need a new barb for my tickler its to big for the hose i am using

[reckid1986]

how did you flip the lever on the msv2, ive tried to get that little pin out but i didnt want to mess it up so i havent done it yet.

[PBChappy]

I could not get the pin out so i just pried the lever off, ground down the pin then used a paper clip to hold the lever back on

[reckid1986]

i see, well pretty good set up you have there. good luck with it.

[PBChappy]

hard routing the hoses with out pinching them cant seem to get it to work yet, eather gets in the way of the mvs-2 lever or the sear hits it when it moves. going to order some more 90deg fittings to see if that helps

[PBChappy]

video of the frame working, have a small leak that the lpr 90deg

http://www.youtube.com/watch?v=pCIL50IOtwE

[Spider-TW]

how did you flip the lever on the msv2, ive tried to get that little pin out but i didnt want to mess it up so i havent done it yet.

I ended up flipping a lever twice. I tried to use low profile barbs facing the MPA-3, but I had the actuator too close to the MSV and could not avoid hose kinking, so I put it back.

With a washer or small nut on the back side, a pair of pliers can push the pin out part way easily. Then you can tap the end with a nail or other soft metal point (to avoid flaring the end of the pin). Then I grabbed the protruding end with a small pair of pliers and pulled, which took a few tries.