Rail question

[ghostdog2019]

Is it possible to mill a splinter rail into a Karta?

Thanks all for any help
-Mike Brothman

[punkncat]

Maybe time for the all too obvious reply...

Why not sell the splinter and use that money to buy a cheaper RT rail. Use the left over money to put towards the milling and anno......

[ghostdog2019]

I know it is something a little more expensive to have milled but I do not want the holes associated with the standard RT rails or emag rails for that matter. From your answer however it sounds to be possible. Is this the case?

-Mike Brothman

[KC]

Send me pics of the rail from the top down... and I will compare it to my 05 karta.

The karta rail is almost the same size as a shadow. All it needs is a little meat on each side... not much at all.

[KC]

Id say no. There is a bit more external meat taken off of a Splinter Rail than your standard RT Pro/E-mag rail. Meat thats necessary in the machining process of a Karta.

I stand corrected.

[ghostdog2019]

Thanks

Well it seems that I may have to change directions with my mag. What rail besides a Karta do you guys think would look the best with a Karta body?

Thanks again all for the help
-Mike Brothman

[zipity_Bop]

Well it seems that I may have to change directions with my mag. What rail besides a Karta do you guys think would look the best with a Karta body?

Thanks again all for the help
-Mike Brothman

they don't make any other rt rails....... w/o the holes?