what hoppers do you all use with pneumags?

[pablo4429]

so which ones do you use with it, i was thinking halo or velocity but i would like to use a revvy if possible

[Smoothice]

That depends on your fingers more then it does on the gun.

How fast can you shoot?

Buy whatever hopper will match your finger speed. Actually buy one that is a little faster cause you will learn to shoot faster if the gun allows it.

I still use a revy with my pneumag. This is due to the fact that my brain won't allow my fingers to move back and forth opposite of each other.

[drg]

i use a V-board Halo; I can walk my pneumag to 16 bps, so a revvy would be a bit too slow. You can always modify your shooting to match your loader, like single-fingering.

[pablo4429]

well on my eblade i can do like 13 or so maybe 14 so i think a revvy ,might just keep up?

[Pneumagger]

it wont... I had an apache that chopped like mad. Even my stock old school halo will chop once the drive cone spring winds down. But I rarely shoot as fast as possible in a game and a revvie would suffice with a level 10.

I would not trust anything except a highly upped Halo/velocity/quloader for a mag without a level 10.

[RobOpel]

Halo b, still got chuffs from the lvl 10 every now and then.

So yeah, if you're quick enough for it, the pneumag will shoot it...I'd reccomend a halo, cause at least if you eventually get faster than it, you can drop in a new board and battery set for less than the cost of a whole new hopper.

[longi]

I used to use a revvy but it chopped quite a bit, so i swapped over to a Halo B, now i don't get quite so many chops.

[t0nnn]

vlocity on speed 6 ...they're amazing. I'm shooting around 15-16bps