possible pneumag resource

[pump]

hey has anyone tried to use a cocker 3way and ram?

not like the parts used are expensive but might be fun to use free stuff to make more stuff

[Ruler_Mark]

what would be easier if you wanted to go this route, is to mod your vert asa into a cocker like front block,, then mount the ram in your triggerframe attached to the solenoid part of a emag sear, then you could effectively have a mech or a pnuematically assiated if you turn your lpr on lower setup

[robertsr1811]

Seen it done before. Punisher or Doc, I forget which.

You set up the trigger that way though, and you start to buy some of the fickleness of the old cocker system...

[FinchMan]

http://punishers-customs.com/gallery.html

[pump]

would there be room in the frame to put the 3way where it might normally go in a pneu and put the ram pushing up the sear vertically?

would the only problem be that Cocker 3 ways have a longer throw than should be?