Need pump mag milling....still

[GroovYChickeN 2.o]

So I'm still looking for someone to mill two rails and a body for me for my pump mags. I know that Rainman on MCB can do it but last time I talked to him his mill wasn't working and he hasn't said anything back about it being fixed. Papa_Smurf also said he would be able to do it but can't do it right now. So I need this done so I can finally finish a project I've started.

Any of you guys know someone that can reliably mill rails and bodies? I say reliable because one of the rails is an eclipse splash rail that would be rather hard to replace if milled wrong.

So anyone know where I should start my hunt again?

[magmonkey]

destructive customs jared has the prints right from agd and he knows what he is doing

[Shane-O-Mac]

Pm'ed you.

[craltal]

I have copies of the prints on my comp at home if anybody needs them...

just pm me...

[Bartman]

I have copies of the prints on my comp at home if anybody needs them...

just pm me...

the full prints? I would love to look at them. If I could.

Bartman

[mr doo doo]

same here groovey, a little stressed out since there isnt anyone to mill bodies and rails, and im confused that no one else is stressing over it i was talking to Rainman, but he's a bit difficult to contact and such.

[craltal]

I've gotten a number of requests for the info that I have. I'm more than happy to email them out tomorrow morning, just pm me with your email addresses and I'll send out a nice big mass email to everyone who wants em. I have the drawings for the rail, rod, as well as a copy of the official instructions and a few other bits including a pic somebody posted up in another thread.