Micromag feed issue

[FOG]

My ptp micro.



Powerfeed lft single screw type has a feed block problem.P-balls are wedging agianst the plug at the bottom of the feedblock causing the balls to hang instead of dropping into the breech, Springfeed, Qloader anything that puts pressure on the balls make it worse.
I can stick a ten round tube in the feed neck an they will fall into the breach Much better than if the balls are being forced.It works pretty well with my ricochet on it but i still have to skake it sometimes.

Recomendations????

Before i fire up my DREMEL !

[Motorhead]

Update your powerfeed plug ... ( Think they are the same one the AM/MM power feed bodies use)

Early version were flat on corner of feed ramp.

New version uses a parabolic curve ramp shape that GREATLY improved feeding.

[FOG]

YUP it does have the old style plug.TY
Can the flat spot be Dremeled out ? Or do i need to buy a new plug ?

[Motorhead]

YUP it does have the old style plug.TY
Can the flat spot be Dremeled out ? Or do i need to buy a new plug ?

New plug !!

You Cannot move the curve without having plug fit shallower, then the ledge created would again hang balz

[FOG]

Gotcha, THanks agin.

[FOG]

Where can i find the new style plug ? I dont see it on the AGD site tho i know they must have them.

[secretweaponevan]

Where can i find the new style plug ? I dont see it on the AGD site tho i know they must have them.

http://store.airgundesignsusa.com/index.cfm?fuseaction=catalog.prodInfo&productID=401&categoryID=92

[FOG]

TY Secret

[secretweaponevan]

no sweat. nice mag