Does anyone know who can mod the Standard CenterFeed Breech to be a Low Rise one. I have the old centefeed that comes with the euro xmags for my xmag. I heard someone on here can do it.
-
-
Talk to A-Tach-One, I think he's the one that does it. -
You heard correct. Contact either A-tach-one of RRFireblade. Both do them.Originally posted by ICOM
A-tach did the feed neck on my SFL. (Once again, I take this shameless opportunity to post pics)
Comment
-
thanks, blade will be doing my devilmag tuning so i will just send him my centerfeed also. Now i just need a new xmag board
cause it might be fried and i dunno if the xmod will work for it.
Comment
-
Correct me if I'm wrong, but an emag board with xmod should support ACE. If you need an ACE board as well, Papa Smurf AND KC should be producing and selling them sometime soon, if not right now.
EDIT: Sorry about that KC, I haven't beene frequenting these forums as much recently, and am not fully aware of what has happened thus far.
Last edited by Andrewliu6294; 03-11-2008, 12:56 PM.Comment
-
I have a Euro Xmag. And the Ace was a different design then the US verisons. There is no ace board. Its programmed in the xmag board itself.Comment
-
No credit, no credit at all.Originally posted by Andrewliu6294
Papa can do the feedneck mod also.
Comment
-
Edited to include credit for you.Originally posted by KCs-RTuleNo credit, no credit at all.
Papa can do the feedneck mod also.
Comment
-
Originally posted by Andrewliu6294Edited to include credit for you.
Thanks.
Comment
-
I have a Euro Xmag. And the Ace was a different design then the US verisons. There is no ace board. Its programmed in the xmag board itself.
Its the exact same design - it just uses a wire harness instead of a pcb. The main board and logic are the same. The only thing you'd likely have to do is a little milling on the x-mag body and frame to accommodate the board.Comment
Comment