Pneumag

[wooky]

Well I have wanted to do this mod for some time now. I took off work today and was doing some stock trading and thought I would go spend some time out and start tinkering around in the garage. I thought today I would try my hand at a Pneumag conversion using a Logic 90* frame and one of Cyberave's pneu-kits. Since I have never done this mod before I really didnt have anything set in stone. I have read just about everything over the years I just dont have any directions, just memory and of course the un-finished version of Cyberave's post that I did not even look at. I have read at it, as he gets time to post but thats about it. Well I take that back, BigE sent me some stuff on it many months ago but it too was very minimal at best. So here are some pics, now I never said I was any good at taking pictures so I hope they came out enough to see whats going on.

Your comments are welcome.

Here ya go:










Wooky

[Mongoose]

your off to a good start.

[rawbutter]

If possible, I would try to straighten out that piston a little so it's not hitting the sear at such a steep angle. That might cause issues over time or during rapid firing. Everything else looks pretty good, though.

Good luck with the mod.

[cyberave68]

See i told you it wasnt that hard that even YOU could do it...lol

Looks good so far. You will want to keep an eye on how you have your piston set to the sear arm. Only prob i see there is when its fired that the ram might go under the sear arm. But other than that it looks good so far. You could also see about setting the MSV-2 higher to leave you more room below for the sleeper mod....

If you have anymore questions you know where to find me....

Cy

[wooky]

Thanks guys!! Hey Cyberave I figured I would put the LPR out in front instead. Yeah, I thought about how the ram is setting and it may go under the sear but I guess we will see. I was trying to get it as close to the bottom as I could for the leverage, easier trigger pull!

I may be contacting you?

Wook

[drg]

I think you may find the piston is too far from the sear at rest
You want it almost touching.