AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026.
Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Anyone know how I could get a red-dot sight on my minimag? I'd like to make my Minimag into a "sniper"
I use to have a red dot sight on my powerfeed mag. The best method is to get a mag sight rail. They usually slide on over the body from the back. Even then you might want to use a raised set of scope rings to get your red dot higher to see past the powerfeed tube. Inside the rings, put a couple of spacers to raise the back of the scope/red dot. This makes it easier to sight the red-dot. If you don't raise the back, you will be near the limits of the setting to compensate for the trajectory of a paintball gun.
Except for the Automag in front, its usually the man behind the equipment that counts.
Comment