Warp Left Tac-Body

[Enhander]

Just a quick question. I noticed on AGD's online store that if you buy a warp tac-body..you have to buy a milled tac rail? So basically its saying If I buy the tac-body without the rail then I cant use the warp left body? The rail that I have on my Tac one looks just like the rail thats in the picture.

[Little_Ho]

you have to notch the rail down for the feedneck to clear the rail siding to the warp body or it will not fit flush. Well since i havent seen a Warp tac yet i assume its the same

[Enhander]

So basically if I get a dremel I can sand down the one side a bit to accomdate the side feedneck?

[ThePixelGuru]

So basically if I get a dremel I can sand down the one side a bit to accomdate the side feedneck?

Yup. The only reason for a special "warp" rail is to make room for the sideways feedneck. Whatever way you hack down the rail is up to you.

[Enhander]

Sounds good, thanks for the info, guess I got some money to spend now lol

[varq]

you could send it into Luke and he will not only notch it for you but also for $25 he can ULE it to make it lighter

http://www.lukescustoms.com/page0001.htm