Warp left ep mag

[Hgblues]

Ok, here it is . Finally done. Warp left, ULE, Intelli frame, X valve, level X , 12v revy, dye drop forward (may change out), J & J edge barrel, Dye sticky grips, Universal T board, Jack hammer 2 lpr reg mounted to asa (for ram) .

mod done sitting at my kitchen table with a dremel, a cordless drill, a few minor hand tools, and Hilltop's ep thread pulled up on my laptop for reference.

[Hilltop Customs]

looks great.....the matching x-valve is just sexy.

Just an idea, idk if it will work or not....I'm guessing you have the LPR angled like that so it doesnt interfere with the screwing in and out the tank? What if you tightened the fitting about 3/4 of a turn more(or 1/4 out)....so the LPR is basically right under the warp bracket. It kind of looks like that might push the warp itself out farther though.

How bout some internal pics

[Hgblues]

at the angle i have the warp , there's not room for the lpr to lay beside it. Where it is now is in a dead space area so it's not in the way of my hand or anything. As far as internal pics, it looks like yours except I came in thru the bottom of the grip with the warp feed wire and the lpr hose.

I do have a slight leak in the valve however. The leak changes somewhat when I turn my thumbscrew slightly. Any idea what that is related to?

[Hgblues]

Fixed my leak, ( o ring) , played my first tourney with my new e p mag tonight. The gun performed better than I expected. I broke 1 ball in a case of paint shooting 13 bps ramp. The 1 ball that broke , I was in a wide open sprint shooting. I'm wondering how much weight I can cut down on my setup. Right now i'm at 8 lbs 8 oz. About the only things i can change would be a lighter rail, and aluminum warp bracket. And maybe a carbon fiber barrel?

As simple as this mod was, I cant believe I havent seen anyone else in this are doing it.

[Ruler_Mark]

verrry nice

[jade_monkey07]

another way to lighten the setup would be q loader.