How many dwell jumpers do you have "enabled" on your warp?

[hitech]

I was wondering how everyone else had theirs setup. I made this a poll to hopfully make it easier for everyone.

[slayer]

my warp spins when I pull the trigger. I think Ihave the jumpers set to the least spin and it works ok

[sniper1rfa]

i have found that with two jumpers on it feed almost exactly 1 ball (a little bit more). with one it feeds 1 1/3 or so. i have mine on 1

[Top Secret]

Please explain this to me. I have an Intellifeed link and had a problem with my warp running a really long time last time I played with my E-Mag.

[hitech]

On the PC board (under the black cover on the back) of the warp there is a set of jumpers that control the length of time the warp spins when it detects a fire signal (either from the intellifeed or the built in sensor). This is called Dwell Time. Each jumper that is in the on position shortens the time the warp disks spin. Here is a link to the Warp manual. See the section titled Jumpers.

http://www.airgun.com/downloads/WarpInstructions.pdf

[hitech]

Thanks for voting. I think I'll start by adding one jumper and playing a day with it. I'll keep doing that until it seems to spin "short" enough. Thanks again.

[RT_Luver]

Tom Kaye told one of my friends one time that the Warp should spin about 1/4 of a tunr each time you pull the trigger. I believe its in the forum some where but I wouldn't search for it.I It was under something about the intellifeed.

[sniper1rfa]

1/4 turn at the factory settings...