Reverse Tac Body?

[pinkanese]

I found this pic and I was wondering if reverse bodies do exist or if this is just a mirrored image.

[RogueFactor]

The sear axle pin goes in on that side. Since you dont see it, Im saying thats a mirrored image.

[pinkanese]

Darn and I had gotten my hopes all up thinking that AGD had finally made somethign lefty friendly

[maniacmechanic]

a std Tac body could be milled for a reverse valve

[pinkanese]

True, but I am not concerned about putting a reverse valve in teh body. The only reason this caught my eye is because I hate teh short rail on the right side. I shoot lefty and as far as I can tell I wouldn't be able to use my short scope on the rail.

[Texas Trigger]

Look at the word "Ricochet" on the loader...It's mirrored.

[egb groupie]

True, but I am not concerned about putting a reverse valve in teh body. The only reason this caught my eye is because I hate teh short rail on the right side. I shoot lefty and as far as I can tell I wouldn't be able to use my short scope on the rail.

It can be done, I used a Simmons 30mm Red Dot I got from Dick's. You have to shorten the rail that will sit on top to almost next to the screw hole. It will then clear the feedneck. It will still be a tight fit off the fitting coming off the valve (Iused a 45* fitting, with a 90* screwed into that), but it'll work.