My Mags are Almost Done

[Don Carnage]

My 2 mags are just about complete.

First my G-Force Karta Mag. I'm still waiting for an internal LPR so I can remove the ghetto set-up on the ASA. But it is shooting like a dream. My top two picks when I decided to put away the A-5 and pick up a high-end mechanical gun were the G-Force Super 68 or a Karta Automag. Neither were in production at the time. Now I have both in one.


Second, my Minimag. It has a Noxx cocker adapter and had had a vertical feed-mod done by Luke's Customs. With the E-Mag pin and a 1K output NitroDuck tank, I can get the RT to burst at about 18 bps. Not too sure about the stock yet.

[questionful]

both look great. I would go about getting some custom grips on the g-force. The plain, flat stock ones don't match the karta body. But definitely cool.

How do you like the feed offset to the left? I would think as a righty (I assume, from your stock) you would want it on the right?

[jade_monkey07]

Love the karta! How are you liking your gforce frame?

[Watcher]

both look great. I would go about getting some custom grips on the g-force. The plain, flat stock ones don't match the karta body. But definitely cool.

How do you like the feed offset to the left? I would think as a righty (I assume, from your stock) you would want it on the right?

But then again, rightys tend to lean out the right side of cover, so a left feed leaves the hopper protected...



Nice mags man, what I woudn't give

How did you get the threaded feedneck on that minimag body?

[Don Carnage]

Love the karta! How are you liking your gforce frame?

The G-Force is pretty cool. But the jury is still out if I prefer it over a high-pressure RT trigger. Nothing against it, I just like the trigger bounce. Sad, I know.

How did you get the threaded feedneck on that minimag body?

It's not threaded. Just Redz Spyder feedneck bolted on it.

I was worried about the Left hopper for a while, but it's not too far to the left that it actually gets in the way. In fact it helps a little, since I naturally lean the gun to the left a little to see past a center feed hopper.

[Hook]

Second, my Minimag. It has a Noxx cocker adapter and had had a vertical feed-mod done by Luke's Customs. With the E-Mag pin and a 1K output NitroDuck tank, I can get the RT to burst at about 18 bps. Not too sure about the stock yet.

Well, if you're unsure about the stock, I'll buy it off you in a heartbeat. LMK if you want to part with it.

[Ruler_Mark]

thoose are 2 very nice guns. congrats

[trevorjk]

how much was looks vert mod?

[Don Carnage]

how much was looks vert mod?

The mod itself is $35. Black Powdercoating is an additional $25.

If you check this Link, you'll find the mod prices and pics about halfway down the page. I'll gladly tell you that Luke's work is great and his turn around time is super fast