has anyone moves the frame/rail holes in a body before?

[pump]

yeah i might have to find a way to hold the barrel into the twist lock body since the retaining pin will have to go

also mill new holes for the sear so the feedneck points down


i wish i could just find a aluminum tube where i could put in the stainless ring for the bolt and thread for cocker barrels, and just drill a hole for the underfeeding

[pump]

guys check this out


Vintage Rex FTW
http://www.vintagerex.com/cgi-bin/in...ie%20Paintball

[Smoothice]

nice. I was wondering how that would line up to just use the sear leg as the trigger. And here I thought I was being innovative with my thoughts

Already been done 12 years ago it seems :rofl:

[pump]

i tried and since its short it doesnt feel too good, but i think ill try with a double trigger shoe on there. but i think the idea that its not directly linked is a reason why its lighter than it being attached