A new ule rail

[DevilMan]

you wear shorts? dang....i didnt think i was the only one that sat at my computer naked eating a bag a cheetos yelling at everyone. i feel so naked now....lol

-Chris

Careful with that and watching p0rn....


Could cause your johnson to turn orange...

DM

[Chris Nearchos]

I will have a hard time sleeping tonight.

as long as you got a good laugh first, thats all that counts. lol

Careful with that and watching p0rn....


Could cause your johnson to turn orange...

DM

man, your telling me. first coule of times that happened i thought i had the orange plauge or something and rushed to the ER.








But anywho, seriously with this rail.

the rail IS NOT from AGD but made by Rouge to full AGD specs.

the rail only has a light cosmetic ability for milling of design (think of it has having the same kind of milling meat as a Emag battery casing....just a "tad" more though.

basicly the rail is meant for deadly people that want a special ULE rail but only have a dremel at hand to use.

there is a bonus when buying the rail, "As a bonus and at no additional charge, a rail bushing and sear axle pin will be included with the RPG Slug rail."






now, my question to rouge if he would be kind enough to answer is the following:


Would we be able to get the "Slug Rail" without the ULE milling?



-Chris

[MANN]

Would we be able to get the "Slug Rail" without the ULE milling?

Per PBL

Have you by any chance considered offering it without the ULE internal milling and front slot machining? This would allow for the purchaser to cut the rail to custom lengths.

Like say you wanted to put a pariah body flush you could have it chopped down and then milled internally as usual.

It must be a niche filled by other rails. A few years back, the AGD Slug rails(non-ULE) were available for purchase for at least a year. As I recall, 3 total sold. Then about a year ago I had a source with some last remaining slugs, and offered them in non-ULE & ULE. To my best recollection, maybe 5-7 sold.

[RogueFactor]

the rail IS NOT from AGD but made by Rogue to full AGD specs.

Yes, absolutely!.

the rail only has a light cosmetic ability for milling of design (think of it has having the same kind of milling meat as a Emag battery casing....just a "tad" more though.

You are right, a tad more. Figure it like this...the Automag/MiniMag rail is 1 1/8" wide, approximately. Anyone who has carved one up(Tyson Machado, El Panda, etc) knows there is plenty enough meat for the DIY'er to do something cool.

The front of an AGD RT Pro rail or E-mag rail is only 1" wide. That should tell you the difference in being able to slice and dice one of these with your own design.

basicly the rail is meant for deadly people that want a special ULE rail but only have a dremel at hand to use.

Exactly! Which is most DIY'ers out there and why this was created for them.

now, my question to rogue if he would be kind enough to answer is the following:

Would we be able to get the "Slug Rail" without the ULE milling?

Not at this time. If in the future demand and volume warrants being able to offer it, it will be an option.