Mkay, so I'm about to send out my E-mag to a certain someone here for some work. I'm having break beam eyes installed and eye covers fashioned (thanks to Chris Nearchos for the eyes and XMag terror for taking the install job 
). I'm also gonna have a little bit more milling done, but my question is, I don't want to take off too much...Are all these areas safe to cut on?
First, mill three grooves like these on the valve. One on top, one left, one right side. The right side will be shorter on account of the macro fitting, red indicates the outline of the cut:
Sorta like the milling done here:
Also, wanna cut out this chunk on the frame:
Mill two gills on either side of my body like this:
My ULE rail wasn't bottomed out:
I want it to be bottomed out and cleaned up a bit like this:
Mill down the area where the jewels were to get rid of that silly looking depression:
Mill the sight rail holes off my rail like this:
Last, mill some depressions into the rear of the frame:
So, is all of this doable, or am I being a bit too ambitious with my milling?
). I'm also gonna have a little bit more milling done, but my question is, I don't want to take off too much...Are all these areas safe to cut on?First, mill three grooves like these on the valve. One on top, one left, one right side. The right side will be shorter on account of the macro fitting, red indicates the outline of the cut:
Sorta like the milling done here:
Also, wanna cut out this chunk on the frame:
Mill two gills on either side of my body like this:
My ULE rail wasn't bottomed out:
I want it to be bottomed out and cleaned up a bit like this:
Mill down the area where the jewels were to get rid of that silly looking depression:
Mill the sight rail holes off my rail like this:
Last, mill some depressions into the rear of the frame:
So, is all of this doable, or am I being a bit too ambitious with my milling?
Comment