who can make me an RT on off

[pump]

not where to get one, but does any machine shop actually have the skill to make one

its for a different shaped RT pin that im trying to get made

[gommie404]

any machine shop will do this for you.. but why dont you just buy one it would be much cheaper.

as a one off this would cost a lot to make.. i can make you one .. but by the time i have done the heat treatment and then had it hard chromed .. and ground to size your be paying quite a lot..

[pump]

any machine shop will do this for you.. but why dont you just buy one it would be much cheaper.

as a one off this would cost a lot to make.. i can make you one .. but by the time i have done the heat treatment and then had it hard chromed .. and ground to size your be paying quite a lot..

well because "its for a different shaped RT pin" trying to get one made for my Zvalve, and also 2 others like the one Electrician made, and one with a ULT sized shaft

those were hard chromed, i polished some to fit looser and it seemed to be all one type of metal?
all i would need is them ground, and polished, or unpolished and a bigger OD so i can polish then without taking off more than i should

[vf-xx]

Honestly, for items this small you might try your local Jeweler. No promises, but my experience is that most machine shops are used to working on bigger things.

[pump]

Honestly, for items this small you might try your local Jeweler. No promises, but my experience is that most machine shops are used to working on bigger things.

eh i think you got a good idea, i know jewelers!!!