Any experience with Ninja regs?

[Wrathbringer]

That CP Micro Razor definitely looks like it would clear the gauge, though just barely.

I say replace it with a CP direct mount and pneumag it!

[SSP REAPER]

I say replace it with a CP direct mount and pneumag it!

agreed !!!

[Shirow]

I am hoping to pneumag it later on, just a bit short on $ right now. I'll send you a PM SSP, thanks

[Watcher]

I have a Ninja in place of my crossfire reg. Swapped them when the CF LP burst disc blew.

So far no major problems. Outputs well, easy to work on.


The only issue I had was if I shot the tank dry in a short period of time (RTing the automag too much ) the reg would leak out of the bonnet at about 400-500 psi.

However, when I contacted Ninja they said to try to clean and re-grease the internals and doing so alleviated the problem.



Outputs a nice and steady 850psi stock, and for my mag that is enough. A rebuild kit with shims or a quick trip to the hardware store with a Micrometer could get it to output higher, though.

[Shirow]

So, the funny thing is, I ordered this pre-emptively because I bent the piston on my flatline putting a new reg seat on and I thought it was screwed. Didn't feel like paying $20+shipping for a new piston when the ninja reg was $33...

So I filled my tank anyway and tried it out and it's shooting more consistently than it ever has.. I will tell everyone from now on to bend their pistons

Either way, I will probably throw the ninja on there next time the flatline goes bad as I'm getting tired of replacing reg seats every few months... but for now I guess my flatline is OK again!

[oldironmudder]

Here is my Alias. The gauge doesnt hit but there is plenty of space from the asa to the cradle bar.

My wife's Texas Storm, has a small drop on it & the gauge would hit. Had to swap drops.

[Shirow]

Thanks for the pic!

[zondo]

Do they come with enough shims to acheive this?

If you order this from ninjapaintball, just tell them that you are running an automag and to see if they can add the shims to up the pressure. They did this for me when I ordered from them.

[Shirow]

If you order this from ninjapaintball, just tell them that you are running an automag and to see if they can add the shims to up the pressure. They did this for me when I ordered from them.

Unfortunately, I already ordered it

[Swamp Thing]

Ninja is great

I called them and asked them shim mine to give max pressure. They only guarantee 900+ and mine is running about 950ish.

Swamp

[StygShore]

Unfortunately, I already ordered it

Call em up and tell them you are using it on amag and the output is too low, they will probably send you shims for free


Styg