So, I received a shim kit from Ninja pro bono (if you need another reason to get a Ninja reg, the fact that they are awesome is a pretty good one) to boost the output pressure on my tank for my RT, and I was thinking of doing that tonight as well as my super duper warpfeed/revvy wiring project (going to sync the feeding of the two as well 12 volt mod the warp through the revvy, which will eventually use an airsoft battery to power both, two 9volts will have to do for now)
However at this point in time, I only have one tank, so I am wondering if boosting the output to around ~950-1100 psi is going create an issue with either my phantom or ego 06? I know the ego has two regulators, I just want to make sure, and the phantom is coming in the mail tomorrow and I haven't had a chance to in to them a whole lot so I don't know if I would need to swap out any springs or something of that sort, but if that is the case I'd just pick up one of those 13/3000 tanks.
However at this point in time, I only have one tank, so I am wondering if boosting the output to around ~950-1100 psi is going create an issue with either my phantom or ego 06? I know the ego has two regulators, I just want to make sure, and the phantom is coming in the mail tomorrow and I haven't had a chance to in to them a whole lot so I don't know if I would need to swap out any springs or something of that sort, but if that is the case I'd just pick up one of those 13/3000 tanks.
Comment