Here it is.
14" DW barrel
RPG ULE body with RPG clamping feed
Halo 35V
Red Tuna Valve
am/mm rail
Intel frame
CP drop and on/off
PE 88/45
I might look into a 12" or 10" DW barrel the 14" + apex is just a bit too long. This is not the gun I will be using at LL3 my emag lowers are getting annoed and my body is still being made. (Mongoose)
How I did it
Used Masking tape and did kinda like the tape mod just to take up the extra room between the adapter and barrel and it protects the CF from the set screws It is Very Very solid much better then just a tape mod and only 15$ for adapter.
adapter here
14" DW barrel
RPG ULE body with RPG clamping feed
Halo 35V
Red Tuna Valve
am/mm rail
Intel frame
CP drop and on/off
PE 88/45
I might look into a 12" or 10" DW barrel the 14" + apex is just a bit too long. This is not the gun I will be using at LL3 my emag lowers are getting annoed and my body is still being made. (Mongoose)
How I did it
Used Masking tape and did kinda like the tape mod just to take up the extra room between the adapter and barrel and it protects the CF from the set screws It is Very Very solid much better then just a tape mod and only 15$ for adapter.
adapter here
