Micromag Pistol

[M98Punk]

First group of parts are here!!

[IMG][/IMG]



Thinking about using a power feed bringing the feedtube close to over the top of the barrel..but I kinda like it all being tight on the right, who knows



Have a Micro Valve just need to find a Alum back half



The pistol next to what will be the purple and green MicroMeg R/T for my wife

[M98Punk]

Oh if you are thinking of doing anything like this IIsports has the PT Extreme feeds for like 5 bucks a pop

[M98Punk]

Just waiting on PTP stuff to arrive. So does anyone know where the cheapest and easiest place to get a male 2 male adapter?

[robertsr1811]

Hardware store in the plumbing section. You're looking for a 1/8 NPT m/m. Easy as pie.

[M98Punk]

Good to know! I heard that it was a 1/4" thou

[PAINTHEY]

Did you ever get yourself a lighter reg?

[M98Punk]

Yeah I found a empty Hurricane. Why you have soemthing?

[PAINTHEY]

[M98Punk]

Would that even be any lighter? IDK I am excited to get going on this.... been bugging Forest to find out when I will be getting my parts cause I can't even mock it up till I get the stuff from PTP

[M98Punk]

Got a hurricane Valve (slight but noticeable difference) PTP actually had to send me another shipment because mine went awol. Hopefully I'll ahve the parts by this weekend.

[M98Punk]

Can I find a Male 2 Male adapter that would fit tank threads at a hardware store? I am headed to one tomorrow to get my male2male for the VA and I am trying to get my UX chamber all plumbed too. Very excited hope to have some dry fires by next weekend!

[M98Punk]

New pictures up tomorrow!
Got my parts!
Dry fired the gun!

Have the Hurricane back. direct feed and PTP Adapter. Took a trip up to ACE hardware today (yet again the box store is worthless) Found an adapter for the Vertical Adapter and the Male 2 Male for the U-adapter to Vertical adapter. But couldn't get a connector for the adapter because the volumizers on Spyders are apparently metric so I'll probably have to get some alum rod and thread them myself.

Now I just need to rut down the direct feed about 1/2" cut off the end of the warp feed adapter and the end of the spring feed and shave off the mounting crap then weld the two together . Oh and ship the valve off to get the loguezzzzzz treatment to bump up the efficiency of a 12 gram

[M98Punk]

[IMG][/IMG]

There she is!



Just need to mill, drill, fill, and will it to be complete

[IMG][/IMG]

I can cut down about 1/4 of an inch off of the direct feed to give her a bit more of a low profile.

[mpsd]

This will look really nice. I just don't get what you're going to do with the Spyder ASAs and volumizers.

[micromag-man]

fun project