Emag Trigger Design

**wetwrks** · 10-23-2011, 02:44 PM

Looks nice.

**GRAYGHOST** · 10-23-2011, 02:51 PM

Emag Trigger

what about a sabre style design with out the center ridge for your finger separation what ever you end up with i will take one

**luke** · 10-23-2011, 03:04 PM

Originally posted by GRAYGHOST

what about a sabre style design with out the center ridge for your finger separation what ever you end up with i will take one

What is a Saber Style?

**GRAYGHOST** · 10-23-2011, 03:21 PM

Emag Trigger

wide at the top tapering down to the bottom with a forward sweep

**luke** · 10-23-2011, 04:02 PM

I'm not sure how much room can be shaved off the center where the magnet and set screw sit, but the design sounds easy enough.

**correia3** · 10-23-2011, 05:14 PM

Dig it.

**FOOGLEMAN** · 10-23-2011, 05:42 PM

What would be the price on these? tunablades are too 'spensive :c

**luke** · 10-23-2011, 06:27 PM

Originally posted by FOOGLEMAN

What would be the price on these? tunablades are too 'spensive :c

Dont know yet, but the more I sell upfront the better deal I can do.

**luke** · 10-23-2011, 06:30 PM

Originally posted by GRAYGHOST

wide at the top tapering down to the bottom with a forward sweep

New pictures in the first post, is that close?

**leloup** · 10-23-2011, 08:09 PM

I like the second style, what is your price point?

**luke** · 10-23-2011, 08:27 PM

Originally posted by leloup

I like the second style, what is your price point?

That is dependant on how many are sold upfront...

**luke** · 10-23-2011, 08:30 PM

I have another design in mind, I'll try and knock it out tomorrow morning...

**OPBN** · 10-24-2011, 05:35 AM

I like the second one as well. Are you planning on with or without roller bearings? I would prefer with.

**Tropical Life** · 10-24-2011, 07:15 AM

Second style looks very clean, glad you stepping into the trigger department.

Comment