12 vt Warp Question

[93klauss]

So I have a warp running on a big cell right now. Thinking of going to the 12 vt, wondering if this will just push balls past the old nubbin style twist lock? I am currently using a hyperframe, x valve, level 10. The warp is not linked to hyperframe.

Thx guys

[Justus]

If I recall correctly, because the discs slip upon resistance in the ball stack, the 12v mod will provide faster loading without putting any more pressure on the detent. I don't have any experience with it though, but I have 2 warpfeeds (one with 12v) and a Minimag with TL barrel that I could try out for you this evening.

[hill160881]

Nope no problem at all. The 9.6 volt battery was running at 12.8 volts

[Justus]

Well, there you have it! Good to know.

[93klauss]

Well thx for the quick response. Next question. Can you Wire the warp directly to the hyperframe? Is there a benefit to a wired setup?

thx again

[hill160881]

Yes it tells your warp the marker is firing and is more effective than the vibration sensor. It does not provide power only a signal that the marker is firing.