Xmod Programmer board

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Sniper Steve
    Registered User
    • Dec 2007
    • 230
    #1

    Xmod Programmer board

    I recently picked up a Xmod Programmer board and not sure what I should do with it. I have another emag that I could upgrade but I am not sure how to do that with this board, or do I really need it if my mag is already upgraded? If I don't need it what is it worth if I wanted to sell it? Also is there a manual somewhere to the xmod board? Just curious any help or input would be appreciated.
    Tags: None
    • knownothingmags
      RKM 3D Designs

      • Apr 2010
      • 4810
      #2
      Originally posted by Sniper Steve
      I recently picked up a Xmod Programmer board and not sure what I should do with it. I have another emag that I could upgrade but I am not sure how to do that with this board, or do I really need it if my mag is already upgraded? If I don't need it what is it worth if I wanted to sell it? Also is there a manual somewhere to the xmod board? Just curious any help or input would be appreciated.
      i would contact tunaman. he is your goto on this subject.
      send him an email or fill out his contact form at tunamart.com.
      logoRKM 3D Designs

        Comment

        • athomas
          Of course it works-its AGD
          • Jan 2002
          • 8039
          #3
          The programmer plugs into the emag board through the 5 pin and 3 pin connectors. Make sure you have the drivers loaded for your programmer. You run the AVR studio programming software that you can get free from Atmel. Load the X-mod, or whatever other emag firmware you want onto the the emag board.
          Except for the Automag in front, its usually the man behind the equipment that counts.

            Comment

            Previous template Next
            Working...