A new RPG trigger

[RogueFactor]

These are finally back!

The trigger on the left is a new addition to the RPG lineup - The RPG SplinterBlade. The trigger on the right is the RPG Viperblade.

E-mail me at [email protected] if you have any questions.

And for a pic:

[SSP-SheiK]

looks like a magnus trigger without the side channels... just my opinion

[RogueFactor]

Or, it looks like the trigger that was designed before that: http://www.mcarterbrown.com/forums/a...ger-works.html

Just my opinion.

[OPBN]

I have one of the Viperblades. Nice trigger. Main issue I have with it is the set screw is too high and makes it difficult to use for a Pneu setup on some frames. Will these be in the same location, or can you lower them?

[RogueFactor]

I have one of the Viperblades. Nice trigger. Main issue I have with it is the set screw is too high and makes it difficult to use for a Pneu setup on some frames. Will these be in the same location, or can you lower them?

Thats never been feasable. Because most pneus are DIY projects, and the frames vary in their geometry for the pneu-setups, there is no consistency. If AGD was to make a pneu-mag, then Id make triggers for those specs.

[OPBN]

Simply lowering the bottom set screw so that the top was 2cm from the top of the trigger would help.

[RogueFactor]

Simply lowering the bottom set screw so that the top was 2cm from the top of the trigger would help.

Im sure Luke could do that mod for you. Only requires drilling and tapping another hole.

[knownothingmags]

dagnabit rogue.

lukes coming out with his.
now you have yours put me down for one of each.
what are prices?

pm when ya get a chance.

thanks,
KNM

[OPBN]

Im sure Luke could do that mod for you. Only requires drilling and tapping another hole.

Or I can just buy a different trigger. Thanks.

The problem with doing that is it leaves a hole that is about where the rod would sit for the pneu set up. It would actually require filling the old hole and tapping a new one. Was really just trying to help make the product more useful to the tinkerer.

[maverick13]

Emailed for a viperblade

[RogueFactor]

The problem with doing that is it leaves a hole that is about where the rod would sit for the pneu set up. It would actually require filling the old hole and tapping a new one. Was really just trying to help make the product more useful to the tinkerer.

I appreciate that. Thanks.

[Silverback]

E-mail sent for Viperblades....

[leloup]

I like them both, what is the price point? Are you making these to order, or just making a batch and selling?

[RogueFactor]

I make most everything to be in stock, its the only way to keep the price reasonable. Thats the reason why I cant take custom requests.

[Madmarx]

I like them both, what is the price point? Are you making these to order, or just making a batch and selling?

This is in the "Paintball Talk" section so he must not even be selling them, just showing what he can do.