Has anyone ever tried this? Would it be hard to do? I'm just wondering because I would like to do this to fit on some of the smaller feednecks in the industry. I have had a hopper slide around one before so lmk. Also bounce some ideas around if you have any.
-
sigpic -
-
Taking a clamping system from another feed neck and using it on a sub zero.sigpicComment
-
What are you trying to do? Put a CCM clamp ring on a sub zero to pull it tighter?Comment
-
Black hockey tape or electrical tape around the hopper feed tube. I have a little Winchester hopper that has a smallish feedneck. Works like a champ.Comment
-
Something to that effectOriginally posted by sjrtksigpicComment
Comment