intellifraME

[ang310fd347h]

wut exactly is special about the intelliframe??? wut does it do?? is there electronics??

------------------
Do U have BaLLs???

Minimag right p/f
ANS Phase II Charger
ANS Phase II Bolt
Custom single benchie
Dye 10" Stainless

[FeelTheRT]

it's mainly for the Warp Feed. It spins everytime u pull it! AMAZING! u can make one though.

[magc68]

its just another 45 grip frame. better than dye/ benchmark. u also have the option of installing a micro switch in the pre drilled holes in the grip to run your warp feed. its easier to do this in that grip than making your own setup. thats all...

[PyRo]

Its a 45 frame for mags made by AGD. Because it is made by AGD you won't have the tolerance problems found in other aftermarket frames, and on the rare occasion you do, they have great customer service, and will get it going for you. As for being mainly for the warp, it has a place inside for a small microswitch, that can be hooked up to the warp or rev, to fire every time the trigger is pulled.

[master_alexander]

for some reason i want to up this very old topic.

[personman]

for some reason i want to shoot you in the face.

[Bad_Dog]

holy thread ressurection batman! I bet pyro was only in his mid 1000's when he made that post

[Automaggot68]

it's mainly for the Warp Feed. It spins everytime u pull it! AMAZING! u can make one though.

Mainly for the warp Feed?
Where the did you read that?
It was an AGD designed double trigger frame that also had intellifeeding capabilities.