-
-
Isnt that for the lip on the barrel retaining pin assembly? -
If that's where the PIM goes then I believe it's for the steel bodies, where the pim is welded on, and so has some extra material around the base of the PIM. If the recess wasn't there, the body wouldnt fit flush, a problem I ran into when modifying an AM/MM rail for one of those bodies, and fixed by taking off a litle material around there.Comment
- AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026. Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Comment