Need some feedback on what kind of frame you would like to see me manufacture.

[mpsd]

Well, since you are already cutting a new one, how about doing a single trigger one this time?

[luke]

[mpsd]

Makes sense but isn't it compatible with a regular AM single trigger?

[luke]

No idea if it is the same, I just used the working geometry off my intelli triggers to make the single trigger.

[mpsd]

As far as I know, it should be the same.

[luke]

[keiko_819]

anxious

[OPBN]

Hmmm might actually have money if this happens soon.

[luke]

Everything should be in place on my side, I have all the tooling and materials so we are down to geometry, if it works we are good to go.

[luke]

I machined several test pieces (4) for the top and last operation and everything is good to go but I ran into some trouble with the narrow trigger slot. I believe I have a solution, but had to place another tool order, so we are in another hold position until tooling arrives.

[sQuidvision]

damn! i have a mag just waiting on one of these!

[rseb4agze]

me too I can't wait to see the finish product of a single trigger version!!!

[luke]

The initial testing on the double trigger is done. Had to make some small changes in tooling and machine programming but it should be ready to go.

I’m going to get to the single trigger frame programming tomorrow and get a prototype cut to show you guys asap so we can get orders going.

The frame came in one ounce lighter than the Intelli Frame.

[knownothingmags]

so are you doing like the m90 did and have a spot for mounting a micro switch, pnumatics,magnets, etc?

i know it would cost more to add those things and do the testing that is required.

your thoughts?

[sQuidvision]

w00t! cant wait to see/order a single!