Who is still making hardlines?

[Freedy500]

get a red X-valve and that will be a sexy beast. Well not like it already is.

[dboggs79]

Check out McMaster Carr. I was looking into doing some awhile back. You can get everything needed from them. Line,fittings, tubing cutter and bender.

[rukh013]

WWA did mine, not sure if he is will still do them.

usualy required sending the gun in for proper spacing

what barrel is that???

[Henchman]

The compression fittings normally found on hardlines will piss you off more in the long run. They arent designed to come on and off frequently.

If you are having macro fitting issues there are a few solutions. There is an oring inside of then, slather them with dow 55 to swell them. Also make sure your macro line ends are cut fresh every now and then. They do tend to wear out making then not want to seal properly.

I agree.
Also, it's nice to know if you are at the field, a macro line is quickly fixed. All you need is an xacto knife and some line.
Done.

[keiko_819]

I can make you a custom hard line using macro fittings

never thought of this but sounds like i need it for my pump...

[Chronobreak]

what barrel is that???

WWA Truth Series

the Justice Series is bored for Freak Inserts

[mpsd]

My Justice one:

[OneSelfLost]

Might want to look into Swagelok compression fittings. They're cheap and easy to fit, all you would need is a wrench. These fit nicely on an SS line. If there is a shop local to you that specializes in hydraulic and pneumatic hoses, drop by there and chat them up. They should have 1/8th inch NPT to Swagelok 90* elbows as well.