Use the normal fittings and as many o-rings as will fit on the hose into the plastic fitting... Unless its constantly flexing while pulling its not going anywhere.
-
Warp Feed Evangelist
My Feedback -
-
How about some out of the box thinking?
What if you took a phnatom (or similar) type horrizontal feed and enlarged the hole that the tube normally screws into so that the warp hose would fit. Another thought I had was cutting one of the tubes down and trying to fit the warp hose over the outside of the tube, you then could secure it with a clamp. This would give you a very low profile setup, just not sure how possible it would be.Comment
-
The phantom breech isn't curved like a power feed plug, it does not respond well to being force fed - the stack will bind up.Warp Feed Evangelist
My FeedbackComment
Comment