LPR Foregrip

[luke]

Updated cad without convex face.

[OPBN]

I think it's the gap between the frame and grip that makes it look a bit wonky. I think it will look great on an AM/MM length flat bottomed rail. Maybe one that is built to purpose with a matching curve on the front.

This.

[barkingspider]

I think it's the gap between the frame and grip that makes it look a bit wonky. I think it will look great on an AM/MM length flat bottomed rail. Maybe one that is built to purpose with a matching curve on the front.

I agree with this comment about the gap. Any chance we could keep a little more material from grip and blend/taper into grip frame so there isn't a gap. Another thought is to make a optional spacer that can attach and stream line with your vert frame, plus allows versatility with other frames where some might not like the spacer. The small gap looks a little odd.

As far as selling us another rail........do you have a vision or design flow that can be incorporated into the grip, vert frame and future body? I see many people loving the concept but having problems with the cosmetic flow of lines. In the long run my wallet would like this idea much better since it minimizes purchasing of repeated parts.

[BLachance75]

I prefer the look of this one.

Do you think you would make a nonLPR version. Or perhaps sell it without the LPR guts.

I honestly don't even care/want it to be a gas through grip. I'd buy one that was hollowed out a little to save weight. Or a blank one that just has the exterior milling and I'll hollow it out myself on the drill press.

[luke]

This mounts in a slot like your RTP VASA, put it where ever you want, the LP air line comes up between the two mounting screws, it's no big deal to move it.
Here it is jammed up against the trigger guard.

[luke]

Do you think you would make a nonLPR version.

I honestly don't even care/want it to be a gas through grip. I'd buy one that was hollowed out a little to save weight. Or a blank one that just has the exterior milling and I'll hollow it out myself on the drill press.

Foregrips would be a separate project, no real advantage piggy backing them on this one.

[knownothingmags]

so are you going with the straight design or the curved design? or both?

[luke]

so are you going with the straight design or the curved design? or both?

Straight or curved, that is the question.
(Wont do both though)

[Xmagterror]

This mounts in a slot like your RTP VASA, put it where ever you want, the LP air line comes up between the two mounting screws, it's no big deal to move it.
Here it is jammed up against the trigger guard.

I love that body! Where did you get it?LOL

[luke]

That's an AO-Mag for sure, the only AGD part is the RetroValve.
It's pretty light even with the SS barrel.

[Fred]

I like both... and would really love to swap this into my Pmag in place of the PTP battery pack I'm hiding the LPR in now...

[TyeStick]

I like them both as well. Is there a rail length that would accommodate the LPR fore grip to sit flush against one of your Lukes frames trigger guard or an intelliframe trigger guard AND sit flush at the end of the rail?

If not, what would it take to manufacture a matching length rail?

[luke]

This Regulator was not designed with a specific rail length in mind. If you want to look for a rail, it is 6.625" from the centerline of the rear thumb screw hole to the front of the LPR. However, you may want to wait until I test the prototype to make sure it even works. Plus we still need to determine if the market will support a run or not.

[jaywmustang]

Updated cad without convex face.

I like this one the best so far

[TyeStick]

+1 ^