i started thinking about this again and was hoping that maybe we could make a post and put all the info here. i know it makes it easier if we can just reference someone to the post.
whats the max efficiency recorded at average speed say above 260 with a 12 gram using a classic valve?
what bolt was used?
was the valve devolumized?
was it run in a vert asa, bottom line, or direct mount setup?
under bore or over bore?
type of on/off?
any other mods?( 8 hole or anything not standard)
it would also be nice to post how to do these mods after the max setup has been established so that others can achieve the same setup.
whats the max efficiency recorded at average speed say above 260 with a 12 gram using a classic valve?
what bolt was used?
was the valve devolumized?
was it run in a vert asa, bottom line, or direct mount setup?
under bore or over bore?
type of on/off?
any other mods?( 8 hole or anything not standard)
it would also be nice to post how to do these mods after the max setup has been established so that others can achieve the same setup.





Comment