Armada-L Rail's

[keiko_819]

Can these be made in a rtp style rail in am/mm length?

[luke]

That's the plan.

[luke]

Slugs are done so we can commence with this project.
After reviewing the design we're going to have to make some tweaks to smooth out some small details.

[luke]

Worked my butt off the last two days and completed 2 Armada rails, we have an RTP and AM/MM rail, both 8 inch in length.
Both can be pump milled.
Pump and non pump will be ULE milled.
Foregrip mount holes (of course)
Tomorrow I will design fixtures and work on the programming so we can get a thread up in the dealer forum.
I'm pretty stoked with the rails, I hope we can sell a batch.

[barkingspider]

Worked my butt off the last two days and completed 2 Armada rails, we have an RTP and AM/MM rail, both 8 inch in length.
Both can be pump milled.
Pump and non pump will be ULE milled.
Foregrip mount holes (of course)
Tomorrow I will design fixtures and work on the programming so we can get a thread up in the dealer forum.
I'm pretty stoked with the rails, I hope we can sell a batch.

[ElPanda]

good work

[swe_crazy]

Pretty sure that I want one of these, if you ship to Sweden? Waiting for the pictures.

[luke]

Sweden is no problem..

[luke]

Currently cutting fixtures...

[TyeStick]

Currently cutting fixtures...

I want to see pictures!!!!!!!!!

[luke]

There you go, (lol) was it all that??
Technically not a fixture, but a soft jaw.

[ElPanda]

Shoulda built a stop into it

[luke]

I like to center the part in the vise. These rails are 9.1" long, vise is 6" long.

[TyeStick]

I knew I was going to end up with a response like that from you Luke. The second I hit 'post', I was doh!

[luke]

lol, What, was that NOT what you wanted to see?