Emag Selector Switches

[havinnoj]

Not supposed to quote prices in this forum but they will be right around the same price as the one on my website.

Thanks Luke. Count me in for a couple.

[luke]

Looks like tooling is on back order for at least a week...

[havinnoj]

To make sure I don't miss these when they're ready, when do you think you can take orders?

[luke]

Can't say for sure with tooling on back order, that's the only thing holding up production.

These will be kept in stock though.

[luke]

Tooling is still on back order.

[luke]

OK, so I got the programs dialed in, need to setup my programs for repeats and the mill for final production and I'll button up this little project.

[splat15k]

OK, so I got the programs dialed in, need to setup my programs for repeats and the mill for final production and I'll button up this little project.

[havinnoj]

Looking good!!

[knownothingmags]

did you do the offset alittle so they don't rub as much?
just wondering.
I diffidently need some,
will these be stocked?

[Swiss Cheeze]

Very nice Luke. Look forward to picking some up.

[Bunny]

Looks great. Can't wait to order a few :-)

[luke]

did you do the offset alittle so they don't rub as much?
just wondering.

It was addressed but differently than what was previously mentioned. I actually redesigned them with the offset, had it programmed ready for production and changed my mind on the direction of the fix. I believe that idea would actually act like a drill bit and end up galling the area under the screw. That is because it would have had two little tiny surfaces to constantly dig into your frame. I guess it would be hidden under the lever, but I think it would cause much more damage.

What I did was redesign the slot. It does not run the full length to the lever anymore, it is only as long as needed to fit the assembly. The idea is, the single larger surface area will cause less damage over time. It's not really something you would consider unless you see the CAD's.

I think this was the best solution after studying the models .

I diffidently need some,
will these be stocked?

Yes, these are a stock item.

[luke]

Looks great. Can't wait to order a few :-)

Cool, these are done and ready to go.

[Swiss Cheeze]

I will take 2 of each.

[knownothingmags]

It was addressed but differently than what was previously mentioned. I actually redesigned them with the offset, had it programmed ready for production and changed my mind on the direction of the fix. I believe that idea would actually act like a drill bit and end up galling the area under the screw. That is because it would have had two little tiny surfaces to constantly dig into your frame. I guess it would be hidden under the lever, but I think it would cause much more damage.

What I did was redesign the slot. It does not run the full length to the lever anymore, it is only as long as needed to fit the assembly. The idea is, the single larger surface area will cause less damage over time. It's not really something would would consider unless you see the CAD's.

I think this was the best solution after studying the models .





Yes, these are a stock item.

awesome on both,
I understood the first part perfectly.
you know me it takes a lot for me to understand things. lol